Datacom Systems D56 Guida alla Risoluzione dei Problemi Pagina 53
- Pagina / 104
- Indice
- SEGNALIBRI
Valutato. / 5. Basato su recensioni clienti
–53–
✱
33 ALARM BELL TIMEOUT 1
0 = No timeout
1 = 4 min
2 = 8 min
3 = 12 min
4 = 16 min
This field determines whether the external sounder will shut off after
time allotted, or continue until manually turned off.
UL installations: must be set for a minimum of 4 min (option 1)
NOTE: If the fire sounder of
✱
32 is programmed for no timeout with
✱
33 programmed for 4 to 16 minutes of alarm bell ringing, and a
burglary alarm is triggered at the same time a fire is detected, the
alarm bell will timeout as specified in
✱
33.
✱
34 EXIT DELAY 9 | 9
00 - 99 = exit delay time in seconds
The system will wait the time entered before sounding an alarm if the
exit door is left opened after the system has been armed.
✱
35 ENTRY DELAY 1 6| 0
00 - 99 = entry delay time in secs.
The system will wait the time entered before sounding alarm upon
entering.
UL installations: must be set for a maximum of 20 seconds
✱
36 ENTRY DELAY 2 9| 0
00 - 99 = entry delay time in secs.
The system will wait the time entered before sounding alarm upon
entering.
UL installations: must be set for a maximum of 20 seconds
✱
37 AUDIBLE EXIT WARNING 1
0 = no exit warning sound
1 = provide exit warning sound when armed AWAY
Warning sound consists of slow continuous beeps until last 5 seconds,
when it changes to fast beeps. The warning sound will end at the
termination of Exit time.
✱
38 CONFIRMATION OF ARMING DING 0
0 = no ding
1 = confirmation ding after arming system
2 = confirmation ding after arming from RF button or RF keypad only
(ding occurs when the system receives the RF transmission.)
Confirmation of arming is 1/2 second external sounder “ding” when
closing report is sent, or at the end of exit delay.
✱
39 POWER UP IN PREVIOUS STATE 1
0 = always power up in a disarmed state
1 = assume the system status prior to power down
When the system powers up armed, an alarm will occur 1 minute after
arming if a zone is faulted.
Note that if the previous state was armed AWAY or HOME, the
system will not respond to sensor changes for 1 minute, which allows
time for sensors such as PIRs to stabilize. This means that if a zone
faults during that 1 minute time period, the system will not detect the
faulting and would power up into the armed ON AWAY or ON HOME
original state.
UL installations: must be 1 (power up in previous state)
- INSTALLATION 1
- INSTRUCTIONS 1
- TABLE OF CONTENTS 3
- LIST OF FIGURES 5
- INSTALLING THE CONTROL 10
- TERMINALS 12
- ON CONTROL 12
- AUX AUX. DATA DATA 16
- – + IN OUT 16
- UL NOTE: 18
- MAY BE USED FOR FIRE 18
- OFF ON 21
- (5800 SYSTEM) 23
- 1 2 3 4 5 28
- Section 7 29
- NO C NC 30
- 32
- 123456 7 34
- CONTROL DATA IN 38
- CONTROL DATA OUT 38
- RADIO DATA OUT 38
- RADIO DATA IN 38
- Section 11. REMOTE KEYSWITCH 39
- 123456789 40
- Typical summary display 41
- Zone Number 41
- Zone Type ↑ 41
- Response Time 42
- (AAV) UNIT 43
- 22 RF SYSTEM 47
- 25 WIRED ZONE EXPANSION 47
- 20 INSTALLER CODE 47
- Zone Number ↑ 48
- Section 15 49
- 0 51
- 0 51
- 0 52
- (enter # +11 for " 52
- (per armed period) 0 52
- 6 53
- 9 53
- 1 53
- Programmed in field ✱88 55
- ( ✱56 Menu Mode) 61
- ↓ Zone Number 62
- X X X–X X X X 63
- RF: 1 s 64
- ( ✱80 Menu Mode) 65
- STOP (STP): 66
- Output Device Displays 67
- (1 sec ON, 1 sec OFF) 67
- * Use 0 (Any) at 67
- Disarming 67
- Section 19. ZONE LISTS ( 69
- 81 Menu Mode) 69
- Section 20 70
- ALPHA DESCRIPTOR PROGRAMMING 70
- ▼ 71
- ✳ ZN 0 1 B A C K 72
- (Word Space) 74
- ✱83 SEQUENTIAL MODE 75
- Serial # Loop # 76
- AND CONTROL (DOWNLOADING) 78
- AWAY (MAX) 82
- AWAY/MAX 82
- STAY/INSTANT, Quick Arm 82
- STAY/INSTANT 82
- MAXIMUM Yes No Yes Yes 85
- ✱24, or transmitter not set 89
- ✱22 not set properly 89
- ✱22 for “1." 89
- SYMPTOM POSSIBLE CAUSE REMEDY 90
- ✱uires operator assistance 90
- REGULATORY AGENCY STATEMENTS 92
- ACCESSORIES 93
- APPENDIX A 96
- – NOTES – 101
- WARNING: TO PREVENT RISK OF 103
Prodotti e manuali riguardandi Networking Datacom Systems D56
(28 pagine)Peavey 26 manuály
Uživatelské manuály a uživatelské příručky pro Mikrofony Peavey 26.
Poskytujeme 1 manuály pdf Peavey 26 ke stažení zdarma podle typů dokumentů: Uživatelský manuál
Commenti su questo manuale